Twin Kvarna

I wanted some light for my computer desk, and I like the Kvarna because it  doesn’t take much space, but I didn’t like that the light is so close to the table surface. So I was at IKEA looking for something I could put under the Kvarna, and the cheapest candidate was… another Kvarna. I cut and stripped the wires from one lamp and thinned the ends. On the other, I stripped a bit of the outer insulation, so I could run 4 wires through the existing hole:

The lamp connectors Lamp connectors

There is room on the connector for 4 wires, so this is relatively straightforward:

Connecting the wires

Testing if everything works:

Testing the twin lamps

After testing, I assembled one Kvarna, and secured the cable with hot glue (I’m using low power LED lights so hot glue should be sufficient):

Assembly

Aligning the connectors

I then glued the two Kvarna together, bottom to bottom, and finished assembly of the second one. Don’t forget to align the indents for the power cable.

Finished! Now celebrate:

Twin IKEA Kvarna lamp

The post Twin Kvarna appeared first on IKEA Hackers.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s